CHINESE/ENGLISH

Coating Inspection
Contact Us

  • 400-022-9917

      

Coating Inspection
current location : HOME PAGE > Coating Inspection> Surface Cleanliness

Elcometer 138 Bresle Salt Kit

Brochure consult

Elcometer 138 Bresle Salt Kit

It is essential that the level of contaminants on a surface is measured prior to application of the coating to ensure the quality of the coating and that its optimum lifetime is achieved.

If the coating is applied to a contaminated surface, which is not properly prepared, it could fail prematurely resulting in costly re-coating and high maintenance costs.

The Elcometer 138 Bresle Kit includes the Elcometer 138 Conductivity Meter. This lightweight, portable conductivity meter accurately measures the salinity of the test samples.

The sensor cartridge can be easily replaced when necessary and displays conductivity in a range of units including: S/cm, S/m, ppm and % salinity.


The Bresle Salt Kit is available in three variants:


Elcometer 138 Bresle Salt Kit with Elcometer 135C Bresle Test Patches- E138-1C

Kit Content:

 
Elcometer 138 Bresle Salt Kit with Elcometer 135B Bresle Test Patches -E138-1 

Kit Content:

 
Elcometer 138B Basic Bresle Salt Kit with Elcometer 135C Bresle Test Patches - E138-EC

Kit Content:

 

Key features of the Elcometer 135C Bresle Test Patch include:
 

  • Easy to peel off after test, leaving no foam on the substrate
  • 19% thicker foam walls than traditional patches - easier to insert a needle
  • Sealed compartment with clear flexible membrane for sampling soluble impurities
  • Covers on both sides to protect against dust and contaminants
  • Supplied with a Certificate of Cleanliness & Test Area
  • Available in boxes of 25 & 100

Pre: Elcometer 130 SSP So...

Next: Elcometer 134S Chlor...